- News
- All
- Aerospace & Defence
- Antenna
- Applications
- Automotive
- Capacitors
- Circuit Protection Devices
- electro-mechanical news
- Filters
- Fuses
- Inductors
- Industrial
- Integrated Passives
- inter-connect news
- Market & Supply Chain
- Market Insights
- Medical
- Modelling and Simulation
- New Materials & Supply
- New Technologies
- Non-linear Passives
- Oscillators
- Passive Sensors News
- Resistors
- RF & Microwave
- Telecommunication
- Weekly Digest
- Video
- News
- All
- Aerospace & Defence
- Antenna
- Applications
- Automotive
- Capacitors
- Circuit Protection Devices
- electro-mechanical news
- Filters
- Fuses
- Inductors
- Industrial
- Integrated Passives
- inter-connect news
- Market & Supply Chain
- Market Insights
- Medical
- Modelling and Simulation
- New Materials & Supply
- New Technologies
- Non-linear Passives
- Oscillators
- Passive Sensors News
- Resistors
- RF & Microwave
- Telecommunication
- Weekly Digest
- Video
Applications e-Blog
How to convert a voltage regulator power module into a current source
#askLorandt video explains MagI³C Current Source, how to convert a voltage regulator power module into a current source.
Read moreDetailsTDK Introduces Special Film Capacitor Dielectric for SiC and GaN DC Link Operating up to 125C
Power transistors based on gallium nitride and silicon carbide impose very high demands on DC link capacitors. TDK has now...
Read moreDetailsMLCC capacitors for RF and microwave applications
Capacitors have numerous applications in today’s RF and microwave systems. The performance characteristics of these components are greatly dependent on...
Read moreDetailsUSB-C Power Board Design Consideration
USB charging has come a long way since the first #USB device was invented. Check out this video to learn...
Read moreDetailsCapacitors for Medical Applications: Component Selection Considerations
Murray Slovick published an overview on TTI MarketEye on capacitor selection considerations for medical application. Capacitors for Medical Applications: Component...
Read moreDetailsESD Basics and Safety Measures
Lorandt explains the basics of electrostatic discharge and corresponding safety measures
Read moreDetailsEffect of Resistor TCR Tracking to Analog and A/D Signal Processing
Ove Hach in his EDN article explains effect of resistor TCR tracking and its precision requirements with respect to analogue...
Read moreDetailsEMC CL and LC Filters Comparison
Bogdan Adamczyk and Dimitri Häring from the EMC Center at Grand Valley State University, USA discuss the second- and third-order...
Read moreDetailsCoilcraft Magnetic Minutes – Inductors Selection for LEDs
Learn about LEDs and driver circuit requirements that impact inductor selection.
Read moreDetailsTDK Explains Soft Termination on Capacitors, Inductors, and Chip Beads for Automotive
Components operating in high vibration and wide operating temperature environments such, as automotive electronics, have to absorb both board flexure...
Read moreDetails
Popular Posts
-
Buck Converter Design and Calculation
-
Boost Converter Design and Calculation
-
Flyback Converter Design and Calculation
-
What Electronics Engineer Needs to Know About Passive Low Pass Filters
-
SEPIC Converter Design and Calculation
-
Why Low ESR Matters in Capacitor Design
-
What is a Dielectric Constant and DF of Plastic Materials?
-
Ripple Current and its Effects on the Performance of Capacitors
-
How to Design an Inductor
-
Filter Poles and Zeros Explained
© EPCI - Leading Passive Components Educational and Information Site